AMD P2 Face Mask:

1. Ensure your hands are clean before handling the face mask.
2. Take care not to touch the inside layer of the respirator that will be in contact with the nose and mouth when unpacking and while donning.
3. Check for defects in the face respirator such as tears or broken loops.
4. Position the label side of the respirator outward and orient the respirator so that the foam nose bridge strip is at the top.
5. Unfold the respirator while holding onto the edges (again being careful not to touch the area that will be in contact with the nose and mouth). Position the unfolded respirator over the nose and mouth and place one ear loop over each ear.
6. Mould the nose bridge wire to the bridge of the nose and while pinching the nose bridge in place stretch the bottom of the respirator over the chin. 
7. Press along the edges of the respirator to maximise the seal.

ViroCLEAR Hand Sanitiser Spray:

1. Apply a small amount of hand sanitiser to the palm of your hand.
2. Rub your hands together, ensuring you cover all surfaces of your hands and fingers.
3. Continue rubbing until the sanitiser has completely evaporated, typically for about 20-30 seconds.
4. Use hand sanitiser whenever soap and water are not readily available, especially before and after touching surfaces or coming into contact with others.

Sonictec Influenza A/B + Covid-19 RAT:

1. Carefully read and follow the instructions provided with the rapid antigen test kit.
2. Collect the samples as directed by the test kit instructions.
3. Perform the test following the specific steps outlined in the instructions.
4. Wait for 15 minutes for the test results to appear.
5. Interpret the test results according to the provided guidelines.
6. Dispose of the test components properly after use.

Hand Wipes:

1. Take a surface wipe from the pack and unfold it.
2. Use the wipe to thoroughly clean hands.
3. Dispose of the used wipes properly after use.